 www.centos.org Forum Index CentOS 6 - Hardware Support  NIC stops working for 3 seconds
|
 Bottom  Previous Topic  Next Topic |
|
|
|
|
|---|
Topic options
Threaded
Oldest First| Poster | Thread |
|---|
|
Re: NIC stops working for 3 seconds | #3 |
|
|---|---|---|---|
|
Moderator
 
Joined: 2007/10/22
From ~/Earth/UK/England/Suffolk
Posts: 9137
|
Please show the output returned by executing the following --
Which of the two devices you have shown above is configured as eth0? |
||
Posted on: 2012/3/1 1:40
  |
 |
||
AlanBartlett
|
Re: NIC stops working for 3 seconds | #2 |
|
|---|---|---|---|
|
Moderator
Joined: 2009/9/24
From Brighton, UK
Posts: 6353
|
So the issue persists if you use the e1000e or sk98lin driver on different ports with different cables? Then that sounds to me like your switch is dodgy - at least that's the only explanation that I can think of.
|
||
|
_________________
Linux/VoIP Systems Administrator |
|||
Posted on: 2012/2/29 11:25
|
|
||
|
NIC stops working for 3 seconds | #1 |
|
|---|---|---|---|
|
Newbie
Joined: 2012/2/29
From
Posts: 9
|
Hello,
I have just recently (last couple of days) started to have issues with my CentOS 6 server. I am get tons, and I mean tons, of the following messages in the sys log : Feb 29 00:04:17 ds9 kernel: e1000e: eth0 NIC Link is Down Feb 29 00:04:21 ds9 kernel: e1000e: eth0 NIC Link is Up 1000 Mbps Full Duplex, Flow Control: Rx/Tx It is always 3 seconds and it is causing problems for me to no end (the issue is the same regardless of which nic I use. The messages can appear several times a minute or in worst case up 3 seconds down 3 seconds. I do not understand why this is happening. Anyone have any suggestions for me on how to solve this. I have the following : Kernel : 2.6.32-220.4.2.el6.x86_64 Motherboard : ASUS RAM : 8GB CPU : Core 2 Quad Q8300 NIC card 1 : Intel Corporation 82567LM-3 Gigabit Network Connection (rev 02) (no board) NIC card 2 : D-Link System Inc DGE-530T Gigabit Ethernet Adapter (rev 11) (rev 11) (pci card) kmod e1000e : v1.9.5 kmod sk98lin : 10.91.2.3-2 dwfa  |
||
Posted on: 2012/2/29 5:17
|
|
||
 Top Previous Topic Next Topic |
 |
|
You cannot start a new topic.
You can view topic.