2.3.1. Disabling ACPI Soft-Off with chkconfig Management

2.3.1. Disabling ACPI Soft-Off with chkconfig Management

You can use chkconfig management to disable ACPI Soft-Off either by removing the ACPI daemon (acpid) from chkconfig management or by turning off acpid.

Note

This is the preferred method of disabling ACPI Soft-Off.

Disable ACPI Soft-Off with chkconfig management at each cluster node as follows:

  1. Run either of the following commands:

    • chkconfig --del acpid — This command removes acpid from chkconfig management.

      — OR —

    • chkconfig --level 2345 acpid off — This command turns off acpid.

  2. Reboot the node.

  3. When the cluster is configured and running, verify that the node turns off immediately when fenced.

    Tip

    You can fence the node with the fence_node command or Conga.


Note: This documentation is provided {and copyrighted} by Red Hat®, Inc. and is released via the Open Publication License. The copyright holder has added the further requirement that Distribution of substantively modified versions of this document is prohibited without the explicit permission of the copyright holder. The CentOS project redistributes these original works (in their unmodified form) as a reference for CentOS-5 because CentOS-5 is built from publicly available, open source SRPMS. The documentation is unmodified to be compliant with upstream distribution policy. Neither CentOS-5 nor the CentOS Project are in any way affiliated with or sponsored by Red Hat®, Inc.