5.2.3. Creating a Swap File

5.2.3. Creating a Swap File

To add a swap file:

  1. Determine the size of the new swap file in megabytes and multiply by 1024 to determine the number of blocks. For example, the block size of a 64 MB swap file is 65536.

  2. At a shell prompt as root, type the following command with count being equal to the desired block size:

    dd if=/dev/zero of=/swapfile bs=1024 count=65536
    
  3. Setup the swap file with the command:

    mkswap /swapfile
    
  4. To enable the swap file immediately but not automatically at boot time:

    swapon /swapfile
    
  5. To enable it at boot time, edit /etc/fstab to include the following entry:

    /swapfile swap swap defaults 0 0
    

    The next time the system boots, it enables the new swap file.

  6. After adding the new swap file and enabling it, verify it is enabled by viewing the output of the command cat /proc/swaps or free.


Note: This documentation is provided {and copyrighted} by Red Hat®, Inc. and is released via the Open Publication License. The copyright holder has added the further requirement that Distribution of substantively modified versions of this document is prohibited without the explicit permission of the copyright holder. The CentOS project redistributes these original works (in their unmodified form) as a reference for CentOS-5 because CentOS-5 is built from publicly available, open source SRPMS. The documentation is unmodified to be compliant with upstream distribution policy. Neither CentOS-5 nor the CentOS Project are in any way affiliated with or sponsored by Red Hat®, Inc.