Search found 5 matches

by thewall83
2019/06/05 11:07:09
Forum: CentOS 7 - Networking Support
Topic: Unable to set static ip on "bridged" network
Replies: 10
Views: 5823

Re: Unable to set static ip on "bridged" network

The correct gateway is 10.5.21.251. I'm sorry, the outputs have been taken after a wrong configuration that I made. I just launched again the commands and the result is the same except for 251 vs 151. I still can't ping machines within 10.5.20.0/23. VMware host get its static IP address with manual ...
by thewall83
2019/06/05 09:08:41
Forum: CentOS 7 - Networking Support
Topic: Unable to set static ip on "bridged" network
Replies: 10
Views: 5823

Re: Unable to set static ip on "bridged" network

Post the output from ip addr show and ip link show and ip route show ip addr show 1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN group default qlen 1000 link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00 inet 127.0.0.1/8 scope host lo valid_lft forever preferred_lft forever ...
by thewall83
2019/06/04 15:01:19
Forum: CentOS 7 - Networking Support
Topic: Unable to set static ip on "bridged" network
Replies: 10
Views: 5823

Re: Unable to set static ip on "bridged" network

Yes, i'm talking about VMware bridged configuration, because I need the server to be reached from other machines on the network.

I can't configure the DHCP server(s) but I know that IP 10.5.20.124 can be used.

To configure guest's interface I used NetworkManager.
by thewall83
2019/06/04 07:01:53
Forum: CentOS 7 - Networking Support
Topic: Unable to set static ip on "bridged" network
Replies: 10
Views: 5823

Re: Unable to set static ip on "bridged" network

I set the interface as Manual. Shown below is the content of /etc/sysconfig/network-scripts/ifcfg-ens33 TYPE=Ethernet PROXY_METHOD=none BROWSER_ONLY=no BOOTPROTO=none DEFROUTE=yes IPV4_FAILURE_FATAL=no IPV6INIT=yes IPV6_AUTOCONF=yes IPV6_DEFROUTE=yes IPV6_FAILURE_FATAL=no IPV6_ADDR_GEN_MODE=stable-p...
by thewall83
2019/06/03 15:38:34
Forum: CentOS 7 - Networking Support
Topic: Unable to set static ip on "bridged" network
Replies: 10
Views: 5823

Unable to set static ip on "bridged" network

Dear all, I'm trying to setup a Centos 7 server on a VMware 12 virtual machine. I have been able to setup the server and the network with dhcp (with VM network configuration as NAT). But when I set the network with static ip (VM network configured as "bridged") i don't have any network service (inte...