HI All,
I just did a clean install on Cent OS 5. I have an
Adaptec 16160 scsi card and an Exabyte VXA3 tape
drive. At BIOS boot, the tape drive probes at position 11.
But, proc only gives me the following:
cat /proc/scsi/scsi
Attached devices:
Host: scsi0 Channel: 01 Id: 00 Lun: 00
Vendor: MegaRAID Model: LD 0 RAID1 476G Rev: 814B
Type: Direct-Access ANSI SCSI revision: 02
Host: scsi2 Channel: 00 Id: 00 Lun: 00
Vendor: PLEXTOR Model: DVDR PX-755A Rev: 1.05
Type: CD-ROM ANSI SCSI revision: 05
No tape drive.
"cat /proc/scsi/aic7xxx/1" give me a ton if info (but does not
show the tape drive on 11, but I am not sure it is suppose to).
What am I doing wrong?
Many thanks,
-T
what happened to my tape drive?
-
- Posts: 400
- Joined: 2007/02/20 04:27:08
- Location: Milky Way/Sol/Earth/USA/Nevada GMT-8