Hello,
Folleing the excelent "how-to" http://www.oracle.com/technology/pub/articles/hunter_rac10gr2_iscsi.html
My test system is CentOS 5.4 and Openfiler 2.3 going to install Oracle 10g all running in VMware ESX 4
everything seems to work OK with the installation process :)
but, I cam in page 2 to:
If you modified the O2CB heartbeat threshold, you should verify that it is set correctly::
[b]# cat /proc/fs/ocfs2_nodemanager/hb_dead_threshold
61[/b]
but I see there is nothing under [b]/fs/[/b] other than [b]/nfsd/[/b] there is no [b]/ocfs2_nodemanager/[/b] !!!!
what do I miss here?
I do not want to cuntinue farther with the setup before I solve this issue (understand it)
cheers
Note: I asked this question in [url=http://forums.oracle.com/forums/thread.jspa?messageID=4170737]Oracle's Forums[/url] too
Testing Oracle RAC on CentOS
Testing Oracle RAC on CentOS
Sorry for my question but did you reboot and verify OCFS2 mount ?
and BTW the manual was written and tested with [url=http://www.oracle.com/technology/pub/articles/hunter_rac10gr2_iscsi.html#6]Oracle Linux[/url]
[quote]This guide is designed to work with Oracle Enterprise Linux Release 5[/quote]
you may find this manual that was tested with CentOS 4
http://www.oracle-base.com/articles/10g/OracleDB10gR2RACInstallationOnCentos4UsingVMware.php
and BTW the manual was written and tested with [url=http://www.oracle.com/technology/pub/articles/hunter_rac10gr2_iscsi.html#6]Oracle Linux[/url]
[quote]This guide is designed to work with Oracle Enterprise Linux Release 5[/quote]
you may find this manual that was tested with CentOS 4
http://www.oracle-base.com/articles/10g/OracleDB10gR2RACInstallationOnCentos4UsingVMware.php