Hello.
I am hoping someone can assist me.
I am trying to build a CentOS 7 Gateway machine to replace pfSense.
In pfSense, I was able to use 1:1 NAT which allowed me to for a single client inside my network to use a specific IP Address from the WAN side.
I have all my static IPs setup on eth0 with aliases for each eth0:1, eth0:2 etc...
I want one of my clients inside my internal network to use an address on eth0:2 for outbound traffic. How would I go about doing this?
1:1 (one-to-one NAT)
Issues related to configuring your network
Return to “CentOS 7 - Networking Support”
Jump to
- CentOS General Purpose
- ↳ CentOS - FAQ & Readme First
- ↳ Announcements
- ↳ CentOS Social
- ↳ User Comments
- ↳ Website Problems
- CentOS 8 / 8-Stream / 9-Stream
- ↳ 8 /8-Stream / 9-Stream - General Support
- ↳ 8 /8-Stream / 9-Stream - Hardware Support
- ↳ 8 /8-Stream / 9-Stream - Networking Support
- ↳ 8 /8-Stream / 9-Stream - Security Support
- CentOS 7
- ↳ CentOS 7 - General Support
- ↳ CentOS 7 - Software Support
- ↳ CentOS 7 - Hardware Support
- ↳ CentOS 7 - Networking Support
- ↳ CentOS 7 - Security Support
- CentOS Legacy Versions
- ↳ CentOS 5
- ↳ CentOS 5 - General Support
- ↳ CentOS 5 - Software Support
- ↳ CentOS 5 - Hardware Support
- ↳ CentOS 5 - Networking Support
- ↳ CentOS 5 - Server Support
- ↳ CentOS 5 - Security Support
- ↳ CentOS 5 - Oracle Installation and Support
- ↳ CentOS 5 - Miscellaneous Questions
- ↳ CentOS 6
- ↳ CentOS 6 - General Support
- ↳ CentOS 6 - Software Support
- ↳ CentOS 6 - Hardware Support
- ↳ CentOS 6 - Networking Support
- ↳ CentOS 6 - Security Support